Reuter Walton Commercial QAQC

• Document No.

• Audit Title

• Client / Site

• Conducted on

  Date

• Prepared by

• Location
  Address

• Personnel

This inspection report should verify that all stucco/EIFS materials are installed per plans, specifications and manufacturer's recommendations. If deficiencies are noted in this report, submit photo documentation of corrected deficiency to RWC Office Administrator.

• Kick out flashings installed where required (pitched roof only).

  Yes

  No

  N/A

• Penetrations have been properly sealed and photographed.

  Yes

  No

  N/A

• Drip cap is installed over all windows and doors (including hollow metal frames).

  Yes

  No

  N/A

• Fasteners used are per plan, specification and siding manufacturer recommendations.

  Yes

  No

  N/A

• If any screws are to penetrate building wrap, a piece of butyl tape has been installed over building wrap prior to screws being installed.

  Yes

  No

  N/A

• Rain screen is being installed per manufacturer's recommendations.

  Yes

  No

  N/A

• Proper flashings are being installed at inside corners, windows, doors and at interface with dissimilar materials.

  Yes

  No

  N/A

• Installation allows for lumber shrinkage and settlement at widows, doors and dissimilar materials.

  Yes

  No

  N/A

• Metal flashings have minimum overlap at seams and are sealed.

  Yes

  No

  N/A

• All flashings are positively pitched away from the building.

  Yes

  No

  N/A

• Decks are flashed per plans and specs. (Includes ice and water).

  Yes

  No

  N/A

• HVAC units are flashed properly.

  Yes

  No

  N/A

• Installed with proper minimum clearance to hard scrapes, roofs etc.

  Yes

  No

  N/A

• System can drain at bottom of walls, windows and all horizontal flashings.

  Yes

  No

  N/A

• Metal lath are proper gauge, overlapped per manufacturer, and installed with the correct side up.

  Yes

  No

  N/A

• Brown coat has had proper cure time prior to proceeding.

  Yes

  No

  N/A

• Expansion and control joint material is approved and is spaced per Architectural elevations. Spacing on Architectural drawings agree with minimum manufacturer's recommendations.

  Yes

  No

  N/A

• Manufacturer's Rep has conducted or is scheduled to perform an Inspection of installation.

  Yes

  No

  N/A

• Crew Foreman has changed. If "yes" - stop work and and review information from Pre-Installation Meeting.

  Yes

  No

  N/A

• 5 or more photos have been submitted with this report.

  Yes

  No

  N/A