Solar Installation report - Roof - V9

Title Page

Scaffolding Health & Saftety

Have you visually inspected the scaff and are you happy they are no visible issues
Valid tag showing name and contact details
Are they any issues with scaffold (gate on wrong side, etc)
Take photos of any issues

Roof Works

Photo's Pre-Installation of Target roof one

Is target roof 2 a different building then target roof one
Photo with tape measure of the width of the roof tile on target roof two
Measured width of roof tile (mm) on target roof two
Photo with tape measure of the EXPOSED height of the roof tile on target roof two
Measured EXPOSED height of roof tile (mm) on target roof two
Photo(s) of the loft of target roof 2

Is target roof 2 a different building then target roof one
Photo with tape measure of the width of the roof tile on target roof two
Measured width of roof tile (mm) on target roof two
Photo with tape measure of the EXPOSED height of the roof tile on target roof two
Measured EXPOSED height of roof tile (mm) on target roof two
Photo(s) of the loft of target roof 2

Photo of Roofing Hook secured to rafters with 2 MCS standard roofing screws on multiple hooks
Photo(s) of target roof one - HOOKED AND RAILED
Is DC cable going through the loft
Take picture of DC entry point
Photo(s) showing how DC connectors behind the panel are neatly secured with zip-ties on rail
Have any tiles been notched

Photo(s) showing panel array and edge of roof(s)
Photo(s) showing rail overhang of at least 50mm and a maximum of 200mm
Does the job have bird netting?
Close up photo(s) of bird netting around solar array(s) uses adequate clips with reasonable spacing, taken from scaffold
Photo(s) WITH a measuring tape from the edge of the panel to the bottom end clamp - do this for every array
Photo(s) WITH a measuring tape from the edge of the panel to the top end clamp - do this for every array
Has the panels been strung as to the original design on the job pack
Take a picture of the stringing configuration (Has it been strung to the OG design)
Is they a jumper cables between panel arrays
Take a picture of ALL jumper cables used and prove they have been secured (with copex etc)
Does the system have an optimizer(s)?
Take a picture of all Optimizer serial numbers and make a note of where they are in a array (must draw a picture)
Example photo of optimizer layout - (Instead of numbers I need serial numbers of the optimizer to the corresponding panel)
Any damages on the panels (scratches, bumps or scrapes)
Photo(s) of solar array(s) taken from ground - if visible from the ground
How many roofs is solar being installed on ?

I confirm I have visually inspected the DC cables including exit to panels through roof tiles and confirm there are no damages? (other than minor superficial scratches)
I confirm I have visually inspected the roof, panels and cables for damage and mechanical/UV protection?
I confirm there are no cables or connectors resting on roof tiles and all are properly fixed to structures in accordance to the manufacturers?
I confirm any damages incurred during installation have been rectified
I confirm the roof is water tight and there are no leaks or potential entries for water ingress - post installation
I confirm all mess made during install has been cleaned and the site has bee left in a safe state (take a pic of site post installation)
Have you left the ladder guard on the ladder when leaving site to ensure no-one can access the scaffolding ?

Customer sign off

I confirm this installation has been installed within MCS guidelines and the customer is happy and content with installation
Customer signature - confirming their are happy with installation